Knowledge Base

How to Remove Hard Drive from Hp Pavilion 17 laptop

This blog post will show you How to Remove Hard Drive from Hp Pavilion 17 laptop. This is useful if you want to upgrade your storage. There are many reasons why someone may need to remove their hard drive, such as upgrading their storage or replacing it with a new one. It might even be that the hard drive has crashed and needs replacing. Whatever your reason, this guide will help you get started on removing your old hard drive and installing a new one in its place! 

The first step is locating the screws at each corner of the back panel and unscrewing them using an Allen key or screwdriver (depending on which type of screws they are). Once these have been removed, slide off the back panel gently but firmly until there is enough room to pull it off.

The laptop should now look like this (without the back panel). The large silver object in the middle of the circuit board is your hard drive, which can be seen underneath where you unscrewed the back panel. Locate the screw holding your hard drive in place and remove it with a crosshead screwdriver. Lift your hard drive up, trying not to damage it in any way.

READ MORE: Best Laptops for Programming under 1000

Once you have fully removed the old hard drive you should be left with something that looks similar to this. You should have a hard drive free of the laptop! Once the old hard drive has been removed, it’s time to install your new one. Simply do the reverse of what you did to get the old hard drive out. Make sure you screw in your new hard drive before replacing it into its slot and then slide on your back panel gently but firmly back into place. Once you’ve replaced the back panel, screw-in every screw once more and your replacement hard drive is ready to go!

This should take under 10 minutes and leave you with a working laptop again. This guide is applicable to all HP Pavilion 17 laptops such as this one Below.

So let’s check out the step-by-step process of How To Remove Hard Drive From HP Pavilion 17 Laptop.


6 Steps: How to Remove Hard Drive from Hp Pavilion 17 laptop

Step 1- First of all, if your system is turned on so please turn off your system by press and hold the power button for a few seconds.

Step 2 – Now, open your laptop and check out the hard drive section. There you will see a small screw. Remove that screw using a screwdriver.

Step 3 – Now, remove your hard drive cover or lid.

Step 4 – After removing the hard drive cover from your system you can see a wire attached to it. Disconnect that wire from your system by moving a little bit up and down.

Step 5 – Here I am connecting another new hard drive on my laptop so you can see that the wire is connected to my new hard drive.

Step 6 – Now, just replace your old hard drive with your new one and fix back it lid again. That’s it.

So, friends, this is how we can remove our hard drive from our laptop or computer. I hope you like my post about How to Remove Hard Drive from Hp Pavilion 17 laptop.


This article has given you a few tips on how to remove the hard drive from your HP Pavilion 17 laptop. It is always best to back up all of your data before removing it, but this process can be done if necessary. If you have any questions or concerns about these steps, please contact us and we will do our best to help!

About the author

Atish Ranjan

Atish Ranjan is a blogger who has been blogging for a long and has good knowledge about Laptops and computers. He pursued Bachelor of Computers, and because of that, he is too much into computers. He loves computers, and love to write about them as well.

Add Comment

Click here to post a comment